The combine harvester is an indispensable piece of equipment for the upcoming harvest. Maintaining your combine doesn't take much time than it looks. However, to have a good result, you need to know the tricks to make the intervention as effective as possible. Find out the details of all the checks that need to be done.
Complete cleaning before wintering
Your harvester is likely to have a long wintering period, which is why it needs the best possible care. Cleaning is an essential step that is highly recommended.
Thorough cleaning is essential to maintain your combine. This consists of washing the removable guards, i.e. the grills, shakers, receiver bottoms. Then dust your machine either with a compressed air system or with a high pressure water jet. It is also recommended to remove grease from certain parts. Among other things, the internal cleaning of a harvester can be done using brushes and scrapers. On the website
Nanolike you can learn more about feeding your cattle.
Necessary checks
Maintaining your combine also means carrying out preliminary checks on the operation of your combine. To do this, inspect each part of your machine for signs of wear. It is important not to skip these steps, as defective parts can prevent your combine from operating properly.
On the other hand, protecting your machine is also a step that should not be burned. Use oil to protect several parts such as chains, knives and reel fingers. Also take care of the electrical connections by using special protective products. Remember to grease the straw chopper joints. The air conditioning system, air filter, gearbox, engine, battery, tyres, all require the minimum of maintenance.
Daily maintenance
To optimize its performance, it is important to maintain your combine regularly. This should be done every day before each harvest. In this case, you will need to check several things: the condition of the radiator, the cooling system, the air filter, the engine oil level, the coolant, the hydraulic oil and possible leaks on the oil and fluid connections. Also remember to take a look at the belt tension, it must be correct, not too loose and not too tight. In case of wear, do not hesitate to replace. Finally, don't forget to fill up the tank and grease all the bearings.
Your harvester is exposed to heat and dust throughout the day, and needs to be cleaned after each use. Accumulated dust must therefore be removed to help the unit cool down in the face of heat, where it is exposed to the risk of fire. Also note that dust is hazardous to health. To remove dust, blow out the combine. What does this mean? Using a thermal compressor, clean the dust and then remove the undesirable elements. Just make sure there is enough pressure to do this.